Home CRAFTS Self-Built Oil Lamp Convection Heater For Eendless Heat

Self-Built Oil Lamp Convection Heater For Eendless Heat

Advertisemen

This is ENDLESS Heat for Your Home WITHOUT Electricity 2.0. When the heater is used for the first time and gets very hot, it will begin to burn off some of the paint from the top of the heater. The same way a wood burning stove does when used for the very first time. After the paint is burned off, it will no longer emit fumes from the paint itself.

source/image: Daniel’s Inventions

If the house is very airtight, one might need to crack a window open, just a little bit to provide oxygen for the heater, or the heater can have a secondary pipe that is bringing oxygen in from outside.The oil tank we built can hold half a gallon of oil, and it takes us a week to go through a single gallon of oil.Watch the video from Daniel’s Inventions:

We are only using the heater for 4-6 hours a day, only when we are there using our shop. Now if you need to run the heater nonstop, you will probably go through more oil each week. To put out the fire, simply put your hand over the fresh air intake pipe and hold it until the fire dies off from lack of oxygen. We are using dry cotton baby wipes as a fuse.

Advertisement

Once the entire tank of oil is empty, we simply install a new baby wipe and refill the tank again. When the oil tank is completely full and the heater has been working for 30 minutes, the heat released from the heater is enormous. One can feel the heat from a distance or just walking by it. It feels like a blast of heat. We estimate that the heat released it approximately as much as two small space heaters at full blast.

Advertisement